A comparison of X-ray fluorescence and wet chemical analysis of air filter samples from a scrap lead smelting operation

Personal and area air samples were taken at a scrap lead smelter operation in a bullet manufacturing facility. Samples were taken using the 37-mm styrene-acrylonitrile closed-face filter cassette (CFC, the current US standard device for lead sampling), the 37-mm GSP or "cone" sampler, the 25-mm Institute of Occupational Medicine (IOM) inhalable sampler, and the 25-mm Button sampler (developed at the University of Cincinnati). Polyvinylchloride filters were used for sampling. The filters were pre- and post-weighed, and analyzed for lead content using a field-portable X-ray fluorescence (XRF) analyzer. The filters were then extracted with dilute nitric acid in an ultrasonic extraction bath and the solutions were analyzed by inductively coupled plasma optical emission spectroscopy. The 25-mm filters were analyzed using a single XRF reading, while three readings on different parts of the filter were taken from the 37-mm filters. The single reading from the 25-mm filters was adjusted for the nominal area of the filter to obtain the mass loading, while the three readings from the 37-mm filters were inserted into two different algorithms for calculating the mass loadings, and the algorithms were compared. The IOM sampler was designed for material collected in the body of the sampler to be part of the collected sample as well as that on the filter. Therefore, the IOM sampler cassettes were rinsed separately to determine if wall-loss corrections were necessary. All four samplers gave very good correlations between the two analytical methods above the limit of detection of the XRF procedure. The limit of detection for the 25-mm filters (5 microg) was lower than for the 37-mm filters (10 microg). The percentage of XRF results that were within 25% of the corresponding ICP results was evaluated. In addition, the bias from linear regression was estimated. Linear regression for the Button sampler and the IOM sampler using single readings and the GSP using all tested techniques for total filter loading gave acceptable XRF readings at loadings equivalent to sampling at the OSHA 8-hour Action Level and Permissible Exposure Limit. However, the CFC only had acceptable results when the center reading corrected for filter area was used, which was surprising, and may be a result of a limited data set. In addition to linear regression, simple estimation of bias indicated reasonable agreements between XRF and ICP results for single XRF readings on the Button sampler filters, (82% of the individual results within criterion), and on the IOM sampler filters (77% or 61%--see text), and on the GSP sampler filters using the OSHA algorithm (78%). As a result of this pilot project, all three samplers were considered suitable for inclusion in further field research studies.     

The Variability of Estimates of Variance, and Its Effect on Power Analysis in Monitoring Design

Power analysis can be a valuable aid in the design of monitoringprograms. It requires an estimate of variance, which may come from a pilot study or an existing study in a similar habitat. For marine benthic infauna, natural variation in abundances canbe considerable, raising the question of reliability of varianceestimates. We used two existing monitoring programs to generatemultiple estimates of variance. These estimates were found to differ from nominated best estimates by 50% or more in 43% of cases, in turn leading to under or over-estimation of samplesize in the design of a notional monitoring program. The twostudies, from the same general area, using the same samplingmethods and spanning a similar time scale, gave estimatesvarying by more than an order of magnitude for 25% of taxa.We suggest that pilot studies for ecological monitoring programsof marine infauna should include at least two sampling times.     

An Evaluation of Selenium Concentrations in Water, Sediment, Invertebrates, and Fish from the Republican River Basin: 1997–1999

The Republican River Basin of Colorado,Nebraska, and Kansas lies in a valley which contains PierreShale as part of its geological substrata. Selenium is anindigenous constituent in the shale and is readily leached intosurrounding groundwater. The Basin is heavily irrigated throughthe pumping of groundwater, some of which is selenium-contaminated, onto fields in agricultural production. Water,sediment, benthic invertebrates, and/or fish were collected from46 sites in the Basin and were analyzed for selenium to determinethe potential for food-chain bioaccumulation, dietary toxicity,and reproductive effects of selenium in biota. Resultingselenium concentrations were compared to published guidelines orbiological effects thresholds. Water from 38% of the sites (n = 18) contained selenium concentrations exceeding 5 g L^-1, which is reported to be a high hazard for selenium accumulation into the planktonic food chain. An additional 12 sites (26% of the sites) contained selenium in water between 3–5 g L^-1, constituting a moderate hazard. Selenium concentrations in sedimentindicated little to no hazard for selenium accumulation fromsediments into the benthic food chain. Ninety-five percent ofbenthic invertebrates collected exhibited selenium concentrationsexceeding 3 g g^-1, a level reported as potentially lethal to fish and birds that consume them. Seventy-five percent of fish collected in 1997, 90% in 1998, and 64% in 1999 exceeded 4 g g^-1selenium, indicating a high potential for toxicity andreproductive effects. However, examination of weight profilesof various species of collected individual fish suggestedsuccessful recruitment in spite of selenium concentrations thatexceeded published biological effects thresholds for health andreproductive success. This finding suggested that universalapplication of published guidelines for selenium may beinappropriate or at least may need refinement for systems similarto the Republican River Basin. Additional research is needed todetermine the true impact of selenium on fish and wildliferesources in the Basin.     

Impact of human activities on the quality of river water: The case of Evrotas River catchment basin,Greece

The impact of point (domestic and industrial effluents) and non-point (agricultural land runoff) pollution sources on the quality of the receiving waters of the Evrotas River (Laconia, Greece) was investigated during a monitoring study from August 1991 to August 1992. The part of the river which was located near the city of Sparta was seasonally influenced by the discharge of effluents from orange juice plants (operating during winter) and by the discharge of septage for the emptying of cesspools which are serving part of the city. The low dilution of incoming pollutants (septage) during the low water flow in summer lead to the decreasing self-purification capacity of the river and the development of septicity conditions in some of its parts. In the vicinity of intensively cultivated areas, the high concentrations of nitrogen and phosphorus which were detected in the river water during winter and spring may be partly attributed to the leaching of the applied fertilizers because of nirogen mobilization and soil erosion, following the season's precipitations. The protection of the Evrotas River water Quality must therefore include adequate treatment of the septage produced in the area, as well as the construction of wastewater treatment plants for the major industries of the area. The non-point pollution could be controlled by the restoration of the Evrotas riparian vegetation, together with a more rational use of fertilizers in the area.     

Water quality test based on dielectrophoretic measurements of fresh water algae Selenastrum capricornutum

A method is described whereby dielectrophoresis of algal cells is used to perform rapid water quality analysis, specifically detecting the presence of CuSO4. The dielectric collection spectrum of the fresh water alga Selenastrum capricornutum was determined for a range of concentrations of CuSO4 from 25 mg L(-1) to 0.25 mg L(-1) for exposure times of 15 min and 18 h. In all cases increasing the concentration of CuSO4 reduced cell collection, but a step reduction was observed in collection between 2 mg L(-1) and 5 mg L(-1). This method has potential for forming a rapid, low-cost test for water quality with broad specificity and significantly reduced analysis time compared to current methods.     

A new device for measuring fluctuations in plant stem diameter: Implications for monitoring plant responses

An electrical device capable of continuously measuring micronsized changes in stem diameter of woody and herbaceous plants is described. Fumigation of sunflowers with automotive exhaust was used to test the ability of the device to detect short-term plant responses.     

Chromium redox speciation in natural waters

Dissolved hexavalent chromium concentrations were determined in river, estuarine and coastal waters of the Humber catchment in north-east England. Samples were collected, filtered, extracted on site and after storage for up to eight days. Hexavalent chromium concentrations did not change by more than 0.05 microg l(-1) (not significant, p = 0.05) over this period. Total chromium concentrations in the catchment were less than 1.0 microg l(-1). This is low in relation to the proposed Environmental Quality Standard. Hexavalent chromium accounted for between 27% and 100% of the total dissolved concentration, with an average of approximately 50%. The proportion of Cr(III) and Cr(VI) in the rivers and estuary were of the same range as previously measured in 1993. The addition of Cr(III) and Cr(VI) to fresh and saline water samples illustrates the complexity of the factors controlling chromium speciation in natural waters. The presence of oxidisable organic matter and the stabilising role of complexing organic ligands are proposed as the main controlling influences of redox speciation in filtered samples.     

Evaluation of interference to conventional and real-time PCR for detection and quantification of fungi in dust

Advances in polymerase chain reaction (PCR) have permitted accurate, rapid and quantitative identification of microorganisms in pure cultures regardless of viability or culturability. In this study, a simple sample processing method was investigated for rapid identification and quantification of fungal spores from dust samples using both conventional and real-time PCR. The proposed method was evaluated for susceptibility to interference from environmental dust samples. Stachybotrys chartarum and Aspergillus fumigatus were used as test organisms. The sensitivity of detection in pure culture was 0.1 spore DNA equivalents per PCR reaction corresponding to 20 spores ml(-1) in the sample. However, 1 spore DNA equivalent per PCR reaction corresponding to 200 spores ml(-1) in the sample was the lowest amount of spores tested without interference in dust samples spiked with spores of either fungal species. The extent of inhibition was calculated using conventional and real-time PCR reactions containing fungal spores, specific primers, specific probes (for real-time PCR) and various amounts of dust. The results indicate that the extent of inhibition by dust on PCR varies with the type and amount of dust, and number of spores. No interference in the analysis of spiked samples was detected from 0.2 mg ml(-1) of four real-life dust samples at p-value >0.05 using 2 x 10(4) spores for conventional PCR and 2 x 10(5) spores for real-time PCR. However, samples containing >0.2 mg ml(-1) real-life dust compromised the PCR assay. These results suggest the potential usefulness of a simple sample processing method in conjunction with PCR for monitoring the fungal content of aerosols collected from indoor environments.     

Spatial contaminant heterogeneity: quantification with scale of measurement at contrasting sites

Material within the terrestrial environment is rarely homogeneously distributed, either spatially or temporally. One consequence of heterogeneity is that uncertainty is usually generated in measurements that are taken with the aim of characterising the environment. For example, a measurement of analyte concentration within soil taken from one sampling location on contaminated land can vary substantially when compared against another sample taken at effectively the same nominal location. The measurement uncertainty arising from the heterogeneity can substantially limit the reliability of the interpretations made upon environmental investigations. The sampling uncertainty usually outweighs the analytical uncertainty from the laboratory, often by a factor of 20 or more. One approach to reducing the uncertainty is to design a more suitable sampling strategy. This might be achieved by predicting the degree of heterogeneity prior to the investigation, but this is often difficult to achieve accurately. Another approach, which was investigated here, is to actually characterise the heterogeneity prior to the main investigation using rapid and inexpensive technology, such as in situ measurement techniques. In situ portable X-ray fluorescence (PXRF) and X-ray microprobe (XMP) techniques were employed to test the feasibility of this approach. Two contrasting contaminated land sites were chosen to characterise the two-dimensional spatial heterogeneity of heavy metal contamination in topsoil at a range of scales (50 m to 0.001 m). The spatial heterogeneity of contaminants, expressed as relative standard deviations, was found to differ between the two sites by a factor of two, largely due to the mode of deposition of pollution. The study also indicated that the heterogeneity did not change systematically with the scale of measurement between sampling locations at either site.     

Application of multicriteria choice-methods in assessing eutrophication

Multicriteria choice-methods, often used in policy analysis, were examined as a methodological procedure for eutrophication assessment. Multicriteria analysis ranked the sampling sites along two coastal areas, according to nutrient and chlorophyll concentrations. Three levels of nutrient loading were revealed, characterizing eutrophic, mesotrophic and oligotrophic waters. These results have been compared to station grouping based on multivariate analysis which indicated similar trends. Multicriteria choice-methods were shown to be an effective methodological tool in assessing eutrophication. In addition, this approach is compatible with multicriteria methods applied on policy-making and therefore the problem of eutrophication can be integrated with plan and project evaluation in environmental management.